Product Description

Whenever you homebrew daily or do it as an occasional hobby, you will constantly disconnect and reconnect kegs and take things apart to clean, which means that you need the G. Francis Corney Keg Ball Lock 12-Piece Set. It includes 2 ball lock disconnect liquid fittings, 2 ball lock disconnect gas fittings, 4 swivel nuts, and 4 hose clamps for 1/4-inch or 3/16-inch ID hoses on your existing ball lock keg. Ensure that the correct fittings are installed on the input and output posts. MFL threaded flare connection allows for quickly changing lines or adding equipment without cutting existing lines. 5/16-inch barb connects to your hose and allows easy cleaning as it screws/unscrews from fitting. The hose clamps tighten hose seal and are winged for easier use (no screwdriver required). WARNING: This product can expose you to chemicals which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Product Features

• DISPENSE YOUR FAVORITE BEVERAGES: Use the G. Francis Ball Lock Keg Fitting Ball Locks 12-Piece Ball Lock Quick Disconnect Set with Liquid & Gas Disconnects, Swivel Nuts, & Hose Clamps to ferment and dispense craft cocktails, soda, and other beverages from your existing keg
• USE YOUR KEG: Each of the ball lock keg connectors (fittings) have an approximate 2.2-inch height and 1.3-inch outside diameter (5.6cm x 3.3cm) and is compatible with ball lock Cornelius (Corny) kegs and keg couple adapters for homebrewing; Hose clamps have 0.2-inch to 0.5-inch (6-12mm) diameter while the barbed swivel nuts have 5/16-inch outside diameter (OD) fitted for 1/4-inch or 3/16-inch inside diameter (ID) hoses on your 3, 5, or 10 gallon keg; Not intended for use on pin lock kegs
• BUILT TO LAST: Keg ball lock quick disconnects and hose clamp wings constructed from ABS plastic that resists rust and corrosion; Swivel nuts and clamps constructed from food-grade stainless steel for maximum strength and longevity
• INSTALL EASILY: Tighten the swivel nut connecting the flare fitting before use; Ensure correct fittings are installed on input and output posts – Light gray disconnect for gas inlet and black disconnect for fluid outlet; To install fittings, pull up lever on ball lock disconnect and push down on the correct ball lock (gas/fluid will flow once connected); 5/16-inch barb connects your hose and screws/unscrews from fitting; Included hose clamps tighten seal on hose and are winged for easier use
• PACKAGE CONTENTS: CO2 Ball Lock Disconnect Stainless Steel Keg Lock package includes (12) pieces total (6 per keg) – (2) ball lock liquid disconnect fittings, (2) ball lock gas disconnect fittings, (4) swivel nuts, and (4) hose clamps for your convenience; Not for pin lock kegs